Table of Contents
Advertisement
5.
Screw
the
middle
alternative left top hinge
fittings,
on the left hand side of cabinet. (Fig.
2 & 3)
6.
Unscrew and transfer the lower hinge bracket
○
5 to the opposite side. At the same time
transfer the stopper pin
designated position of the lower hinge
bracket. (Fig. 1)
7.
Relocate the upper and lower door shaft
assembly to the designated positions.
8.
Set the upper glass door to the designated
position and install the two lock screws to
connect the upper door shaft assembly
with the upper glass door and tighten them
before the door is leveled. (Fig. 2)
9.
Set the lower glass door to the designated
position and install the two lock screws
connect the lower door shaft assembly
with the lower glass door and tighten them
before the door is leveled. (Fig. 1)
10. Remove the handles from the left side of the
doors and install them on the right side.
USE ATTENTION
Only store wine in unopened bottles. Always
•
lay bottles on their side for storage.
Do not overload the cabinet.
•
Do not open the door unless necessary.
•
Do not cover shelves with aluminum foil or
•
any other shelf material which may prevent air
circulation.
Should the unit be left empty for long periods
•
it
is
suggested
unplugged, and after careful cleaning, leave
the door ajar to allow air to circulate inside the
cabinet
in
order
condensation, mold or odours forming.
○
hinge
6
and
the
○
9 included in the
○
4 to the opposite
○
○
1 to
○
that
the
appliance
to
avoid
possible
OPERATING YOUR
APPLIANCE
This appliance is designed for operation at certain
ambient
specified on the rating plate.
The appliance may not work properly if it is left for a
long period at a temperature outside the specified
range. For example, placing your unit in extreme
cold
or
temperatures to fluctuate. The range between 5ºC
and 22ºC (41ºF and 72ºF) may not be reached.
Climate class
SN
N
ST
7
T
NOTE:
internal temperature if the ambient temperature
where the unit is located is lower than the set
temperature.
2
NOTE:
When you use the appliance for the
•
first time or restart the appliance after
having been shut off for a long time,
there could be a few degrees variance
between the temperature you select
and the one indicated on the LED
readout. This is normal and it is due
to the length of the activation time.
Once the unit is running for a few
hours everything will be back to
normal.
If the unit is unplugged, power lost, or
•
turned off, you must wait 3 to 5
minutes before restarting the unit. If
you attempt to restart before this time
delay, the unit will not start.
is
9
temperatures.
The
hot
conditions
may
Ambient room temperatures
+10° C to +32° C
+16° C to +32° C
+18° C to +38° C
+18° C to +43° C
Units with no heater will not raise its
climate
class
is
cause
interior
Advertisement
Table of Contents
