Safe Servicing Practices Quick Reference Sheet Owner’s Guide and Parts Information Contact Information General information Safety Precautions Door Adjustment Specifications Sample Wiring Diagram Compressor/Electrical Specifications Compressor Pins Specifications Refrigeration Systems Refrigeration System Diagnosis Guide Troubleshooting Not Refrigerating (compressor and fan are operating) Not Refrigerating (compressor not operating - fan operating) Not Refrigerating (compressor and fan not operating) Compressor Overheating...
GENERAL INFORMATION Door Adjustment All model doors are aligned at the factory before ship- Safety Precautions ment. Occasional readjustment may be necessary, es- Do not attempt to service or repair the unit until you pecially if an Overlay Panel is installed. The following have read the entire procedure.
Page 6
Note: The hinge plate on some models do not have the holes slotted for adjustment. New hinge plates are available from Electrolux Parts. 3. With door upside-down, inspect the bottom hinge plate mounting holes. a. If your plate has slotted mounting holes, loosen but do not remove the two hinge plate screws.
Compressor/Electrical Specifications: OVERLOAD PROTECTOR START RELAY RELAY COVER Compressor Pins: To measure start winding resistance, measure across the C-S pins. To measure run winding resistance, measure across the C-R pins. These pins should never measure any resistance to ground. This would indicate a shorted compressor. Specifications: Start Winding Resistance: 28 OHMS.
REFRIGERATION SYSTEMS Normal Vapor/Compression Cycle Refrigeration • Refrigerant is pumped from the compressor to the condenser as a high pressure, high temperature vapor. • As the refrigerant cools in the high pressure condenser, the vapor condenses to liquid. During this phase change, a great amount of heat is rejected with the help of the condenser fan. •...
Troubleshooting DANGER DO NOT service the unit until the main electrical power has been disconnected. Problem Cause Correction a. Little or no frost pattern on 1. Not refrigerating (compressor a. Check for sealed system leak evaporator. and fan are operating). or restriction.
Problem Cause Correction a. Door gasket not sealing a. Adjust door hinges or replace 7. Excessive frost build-up. properly. door gasket. Cause b. Door out of alignment. b. Align fill door hinges. c. Water soaked cabinet c. Replace foamed cabinet insulation.