Cabinet Shelves; Operating Noises; Bottle Storage - Electrolux EWK0462X Instruction Manual

Sabbath mode can be exited by repeating the
above process. The
automatically exit after 96 hours.

CABINET SHELVES

IMPORTANT - Do not cover any part of the
•
shelves with aluminum foil or any other
material that will
circulation within the cabinet.
To prevent damaging the door gasket, make
•
sure the door is fully open when pulling
shelves out of the rail compartment.
For easy access to the bottles stored, pull the
•
shelves out approximately 1/3. The shelves
are designed with an emergency stop to
prevent them being removed too far when
loaded.

OPERATING NOISES

The unit is cooled by a compressor (refrigeration
aggregate). The compressor pumps coolant
through the cooling system, producing operating
noise. Even when the compressor cuts out,
noises caused by changes in temperature and
pressure are unavoidable. Operating noise will be
most audible immediately after the compressor
cuts in. It becomes quieter as the operating period
continues.
The following noises are normal and occur from
time to time:
- Gurgling sound, caused by the refrigerant
flowing through the appliance's coils,
- Humming noise
compressor. This noise can get louder for brief
periods when the motor is switching on.
- Cracking/popping sounds, resulting from the
materials contraction and expansion due to
temperature variations,
- Fan operating sound, to circulate the air within
the wine cabinet.
Unusual noise is normally the result of improper
installation. Under no circumstances must tubing
come into contact with a wall, other furniture or
with other tubing.
Where the unit is installed in open-plan kitchen or
in partition walls, the level of operating noise will
be heard more acutely. However, this is due to the
surrounding architecture and not to the unit.
An individual's perception of noise is directly
linked to the environment in which the unit is
located, as well the specific type of models. Our
appliances are in line with international standards
for such appliance and in line with the latest
technical developments. But please remember
Sabbath Mode
prevent adequate
made by the motor
that the noise of the compressor and the coolant
will circulating in the system is unavoidable.
DEFROSTING / HYGROMETRY /
VENTILATION
Your unit is designed with an automatic defrost
system. During the "Off-cycle" the evaporator behind
air
the rear wall of the unit defrosts automatically. The
condensate collects in the drain trough behind the
rear wall of the unit, and part of it flows through the
drainage hole into the drip tray by/above the
compressor. The heat is transferred from the
discharge pipe or compressor and evaporates any
condensation that has collected in the tray. Part of
the remaining water is collected within the unit for
humidity purposes.
This system enables the creation of the correct
humidity level inside your unit required by the
natural cork to maintain a long lasting seal.
The appliance is not totally sealed: fresh air
admission is permitted through the drainpipe. Air is
circulated through the unit by means of a fan / fans
and the hollow shelves.
NOTE:
evaporator if the unit is repeatedly opened in a high
heat or high humidity location. If this frost pattern
does not clear within 24 hours, your unit will require
manual defrosting.

BOTTLE STORAGE

Many bottles may differ in size and dimensions. As
such the actual number of bottles you may be able
to store may vary.
Bottle capacities are approximate maximums when
storing traditional Bordeaux 750 ML bottles and
include bulk storage.
You may load your wine bottles in single row or by
stacking while taking note of the following: if you do
not have enough bottles to fill your wine cellar, it is
better to distribute the load throughout the wine
cellar so as to avoid "all on top" or "all below" type
loads.
- Do remove or relocate adjustable wooden
shelves to accommodate larger type of bottles
or increase the capacity of the cellar by
stacking the bottles up when necessary. (See
removing shelves)
- Keep small gaps between the walls and the
bottles to allow air circulation. Like an
underground cellar air circulation is important
to
homogeneous temperature within the cellar.
- Do not over load your wine cellar to facilitate
air circulation.
- Avoid obstructing the internal fans (located
inside on the back panel of the wine cellar).
12
Frost may be accumulated
prevent mould and
on the
for a better