Changing The Cloning Password - Panasonic TH-65SQ1W Operating Instructions Manual

8
Select [Execute] with
<ENTER>.
LAN data cloning
Execute
Select display
Write protect
Status Display name
SQ1-001
SQ1-002
SQ1-004
SQ1-005
SQ1-014
SQ1-006
SQ1-041
SQ1-009
Note
●
Data cannot be copied to the display for which
[Write protect] is set to [On]. Set this to [On] to
prevent [LAN data cloning] from being performed
mistakenly when data copy is not necessary.
●
Once [LAN data cloning] is performed, [Write
protect] is set to [On].
9
A confirmation window appears.
Select [Execute] with
<ENTER>.
LAN data cloning
All data for the selected displays will be changed.
Are you sure you want to execute?
Execute
Data copy to the display starts.
LAN data cloning
DO NOT unplug your Display!
Cloning in progress, please wait.
10
The exit screen appears.
The green mark on the list shows the data has been
copied successfully. The red mark shows failure.
If the red mark appears, check the LAN cable
connection or power status of the display of the copy
destination.
LAN data cloning
Cloning finished.
Status Display name
SQ1-001
SQ1-002
SQ1-004
SQ1-005
SQ1-014
SQ1-006
SQ1-041
SQ1-009
and press
Off
IP address
192.168. 0. 1
192.168. 0. 2
192.168. 0. 4
192.168. 0. 25
192.168. 0. 31
192.168. 0. 7
192.168. 0.124
192.168. 0.211
and press
Return
IP address
192.168. 0. 1
192.168. 0. 2
192.168. 0. 4
192.168. 0. 25
192.168. 0. 31
192.168. 0. 7
192.168. 0.124
192.168. 0.211
If the data copy has finished, the message appears
on the display of the copy destination.
Cloning finished. Please turn off the power.
11
Press the power button on the remote
control to turn the power off, and
then turn the power on. Or remove
the power plug from the outlet once,
wait for 30 seconds or more, and then
insert the power plug.
The copied content is applied to the display.
Note
● When the data is copied with [POWER button
lock] set to [On]
If the power is turned off using the power button of
the main unit in step 11, the power button of the main
unit is locked, and the power cannot be turned on
again. In this case, remove the power plug, wait for
30 seconds or more, then connect the power plug
again, and wait for a few minutes. Power indicator:
Lights up in red (standby). Turn the power on using
the remote control, and set [POWER button lock] to
[Off]. Then, turn the power off using the power button
of the main unit, and turn the power on again.

Changing the cloning password

Changes the cloning password required
to use the cloning function.
1
Insert the USB memory device to the
USB terminal on the bottom of the
display.
The password input screen is displayed.
2
Enter the current password, and press
[Ok].
3
Enter the new password, and press
[Ok].
4
Enter the new password again for
confirmation, and press [Ok].
Note
●
The initial password in the factory default state is
[AAAA].
●
Change the password periodically, and set one which
is difficult to guess.
●
For initialization method for the cloning password,
consult the dealer where you purchased the product.
133
English