Set Day And Time; Adjust Temperature (Temporary Hold); Adjusting Comfort Activities (See Comfort Profiles - Carrier Infinity SYSTXCCITC01-B Owner's Manual

When the feature is enabled and AUTO mode is selected, the simultaneous heating and cooling
demand auto mode will alternate between heating and cooling, depending on demand, every
half hour. This may result in higher energy usage but provide the benefit of greater comfort.
Your installing contractor is able to enable this feature, if desired. (This feature is only available
with zoned systems).
• If HEAT is selected then the Infinity System Control operates only the heating system.
• If COOL is selected then the Infinity System Control operates only the cooling system.
• If FAN ONLY is selected, then the Infinity System Control operates the indoor fan but
heating, cooling, humidification or dehumidification will not take place.

3.2. Set Day and Time

• To set the day and time for your home screen enter the Main Screen by touching anywhere on
the Control.
• Touch the DAY and TIME label located at the top middle of the screen or access by going
through the menu screen (see page 32).
• To set the HOUR, MINUTE, MONTH, DAY, or YEAR touch the feature you wish to
change.
• Use the Up (Y) and Down (B) buttons to make the appropriate changes.
• When you have completed all of the settings, touch SAVE.
• If you make a mistake you may touch CANCEL and begin again.

3.3. Adjust Temperature (Temporary Hold)

The Infinity System Control allows you to temporarily override your programmed schedule by
adjusting the indoor temperature at any time to meet your needs.
NOTE: The Infinity System may seem slow to react to set point, activity and system mode
changes. This is normal, as the system will ramp up capacity and fan speeds slowly to achieve
the proper level of home conditioning, while avoiding wasting energy, stressing home circuits
and dimming lights with a "hard start."
3.4. Adjusting Comfort Activities (See Comfort Profiles on
page 14)
• To adjust the comfort activity, enter the Main Screen by touching anywhere on the Control.
• Touch the activity/top button under the Touch 'N' Go® feature on the left side of the screen;
then select the desired activity of HOME, AWAY, SLEEP, or WAKE.
• Use the Up (Y) and Down (B) buttons to change the time to temporarily hold the desired
temperature in 15 minute increments.
• When the correct time interval is displayed, touch DONE.
• To return to the scheduled program, touch HOLD UNTIL, and then select PER
SCHEDULE.
9