How To Add Fluid - Chevrolet 2000 Prizm Owner's Manual

3. Check both sides of the dipstick, and read the lower
level. The fluid level must be between the two
dimples in the hot range.
4. If the fluid level is in the acceptable range, push the
dipstick back in all the way; then press the tab down
to lock the dipstick in place.

How to Add Fluid

Refer to the Maintenance Schedule to determine what
kind of transaxle fluid to use. See "Recommended
Fluids and Lubricants" in the Index.
If the fluid level is low, add only enough of the proper
fluid to bring the level into the area between dimples on
the dipstick.
1. Pull out the dipstick.
-
2. Using a long neck funnel, add enough fluid at
the dipstick hole to bring it to the proper level.
It doesn't take much fluid, generally less than
one pint (0.5 L). Don't overfill.
NOTICE:
We recommend you use only fluid labeled
R
-
DEXRON III, because fluid with that label is
made especially for your automatic transaxle.
Damage caused by fluid other than DEXRON
is not covered by your new vehicle warranty.
3. After adding fluid, recheck the fluid level as
described under "How to Check."
4. When the correct fluid level is obtained, push the
dipstick back in all the way; then press the tab down
to lock the dipstick in place.
R
-
III
6-19