Lower Heater - Panasonic NN­GS595A Service Manual

10/24/2016
1.Please grease enough silicon evenly between the interface of heater DU and bottom of oven cavity. (about 0.3mm
thickness), this is for good conductibility.
2.Tighten 4 screws and make sure there is no gap between heater DU and bottom of oven cavity.
3.Do not forget to screw the thermal cutout bracket along with heater Du.
To install thermistor
NOTE:
Before installing thermistor, please fill enough silicon grease into the installation hole of heater DU for good conductibility.
4.12 Lower heater
1. Remove tubes from both ends of copper pipe.
2. Remove 1 screw holding air guide B on the base.
3. Remove left and right door key springs from door arm.
NOTE:
Please support door before operation.
4. Turn over the microwave oven and remove all screws holding base on oven assy & two hinges.
NOTE:
Do not remove two screws holding left and right hinge on the bottom of cavity front plate.
5. Remove base from oven assy.
6. Disconnect 2 lead wires from the right side of lower heater.
7. Remove 2 screws linking the terminals of lower heater.
8. Use tools such as pliers to turn out the tab located on the left side of lower heater.
file:///C:/Users/sh.dehghani/Desktop/NN­GS595AOTSVC_PHAMOS0511035C3/viewing/SGML_VIEW_DATA/OT/NN­GS595A/SVC/PHAMOS0511035C3/inde...
XML Service Manual
9/9