Windshield Wipers - Chevrolet 2000 Cavalier Owner's Manual

If a bulb is burned out, replace it to help avoid an
accident. If the arrows don't go on at all when you
signal a turn, check the fuse (see "Fuses and Circuit
Breakers" in the Index) and for burned
Headlamp High/Low Beam Changer
To change the headlamps from low beam to high or
high beam to low, pull the turn signal lever all the way
toward you. Then release it.
Flash-to-Pass
This feature lets you use your high
signal a driver in front of you that you want to pass.
To use it, pull the turn signal/multifunction lever toward
-
you until the high beam headlamps come on, then
release the lever to turn them off.
-
out bulbs.
When the high beams
are on, this light on the
instrument panel cluster
will also be on.
-
beam headlamps to

Windshield Wipers

You control the windshield wipers by moving the stalk
with the windshield wiper symbol on it up or down.
For a single wiper cycle, push the stalk down to MIST,
then release it. The wipers will stop after one cycle.
For more cycles, hold the wiper stalk down longer.
For steady wiping at low speed, move the wiper stalk up
-
to the (1). For high speed wiping, move the stalk up to
(2). To stop the wipers, move the stalk to OFF.
2-35