Panasonic CS-HZ25WKE Service Manual page 133

18.3.1.2 Setting Connection Network
Connection Guide
Step1 Step1 Step Step2 Step3 Step
Make sure smartphone is connected to same
wireless network.
When Wireless LAN LED is ON, tap "Next".
Point the remote control to air‐conditioner
and press the "Wireless LAN" button one.
When Wireless LAN LED is blinking, tap "Next".
Wireless LAN
S E T
CAN CE L LED
Wireless LAN
LAN button
Next
Cancel
1. Ensure Wireless LAN LED is ON.
point the remote control to air conditioner
and press Wireless LAN
Wireless LAN LED changed to blinking.
18.3.1.3 Connection Network Using WPS Mode (Method 1)
Connection Guide
Step1 Step3
Step2
The router supports WPS.
Connect with WPS mode
The router does not supports WPS.
Connect with AP mode
Cancel
1. Select 'Connect with WPS mode'.
Step1
Choose the button that matches the status of
Wireless LAN LED.
*Wireless LAN LED's position and colour varies
for different models
LED is OFF
LED is ON
LED is Blinking
2. When Wireless LAN LED is blinking,
select preferred connection setup mode.
button until the
Connection Guide
Step1 Step2
Press the WPS button on the router to establish
connection.
Tap "Next" after the router is ready for connection
Next
Cancel
2.
Press the WPS button from the router
that will be connected to an air
conditioner.
Check the status of Wireless LAN LED
●
on the remote control. If the Wireless
LAN LED is OFF, press the Wireless
LAN button to enable the Wireless
LAN connection.
Connection Guide
Step3
Step2
Cancel
Step3
133
Connection Guide
Step1
Step2
The router supports WPS.
Connect with WPS mode
The router does not supports WPS.
Connect with AP mode
Cancel
3. Select the preferred router
support connectivity mode.
Connection Guide
Step1 Step2 Step3
If Wireless LAN LED is OFF during the connection
setup, please press "Wireless LAN" button once
to enable the Wireless LAN before proceeding to
step .
Press and hold "Wireless LAN"button for 5
secs until easy setting " 1" is shown.
Point remote control to air‐conditioner and
press "SET" button once.
After step & have been done, tap"Next".
SET
CAN CE L
Next
Cancel
3. Ensure Wireless LAN LED is ON. Press
and hold the Wireless LAN
for 5 seconds until "1" is shown on the
remote control and press
to the air conditioner.
Step3
button
pointing
SET