Datamax PrintPAD Series User Manual page 9

Audio Indicators
Beep(s)
1 Printer wakes up.
2 Out of paper.
3 Low battery.
1 short RF power is on (when blue, RF power button is pressed and
power was turned off).
2 short RF power is off (when blue, RF power button is pressed and
power was turned on).
1 long Boot code is starting or restarting (when downloading new
firmware).
8 short CRC error in firmware.
Radio LED
Radio LED
Blue flash - slow
Blue flash - fast
Off
Power LED
Power LED
Off
Red flash
Green
CardReader Audio Indicators
Magnetic
Beep(s)
1 long
2 short
Using DEX/UCS Capabilities
Figure 15
The direct exchange (DEX)/UCS port can only be used with the Datamax-O'Neil approved DEX cable (P/N 210237-
xxx). When the DEX cable is plugged into the data port, the printer automatically turns off to allow data transfer
between the handheld and the DEX port. Remove the DEX cable to resume connection to the printer.
Note: Do not unplug the cable in the middle of a data transfer session.
Your application needs to be programmed to communicate in the DEX/UCS language.
Description
RF power is on and printer is asleep.
RF power is on and printer is awake.
RF power is off.
Description
Printer is asleep.
Paper out.
Unit is awake.
Description
Bad read.
Good read.
DEX/UCS port
None.
Install paper.
Charge battery.
None.
None.
Redownload firmware.
Redownload firmware.
Action
None.
None.
7
PrintPAD MC65 USER'S GUIDE
Action