Table of Contents
Advertisement
Thrn Signal and Lane Change Indicator
The turn signal has two upward (for right) and two
downward (for left) positions. These positions allow you
to signal a turn or a lane change.
To signal a turn, move the lever
a l l
the way up or down.
When the turn is finished, the lever will return automatically.
Q
An arrow on the instrument
panel will flash in the
direction of the turn
or lane change.
To signal a lane change, just raise or lower the lever
until the arrow starts to flash. Hold it there until you
complete your lane change. The lever will return by
itself when you release it.
If you move the lever all the way up or down and the
arrow flashes at twice the normal rate, a signal bulb may
be burned out and other drivers may not see your
turn signal.
If a bulb is burned out, replace it to help avoid an
accident. If the arrows don't go on at all when you
signal a
turn,
check for burned-out bulbs and a blown
fuse (see "Fuses" in the Index).
Headlamp High/Low Beam Changer
To change the headlamps from low beam to
high or high
to low, pull the turn signal lever
a l l
the way towards you.
Then release it.
When the high beams are
on, this light on the
instrument panel also will
be on.
2-34
Advertisement
Table of Contents
