Panel Doors - Chevrolet 1997 Tahoe Owner's Manual

Table of Contents

Advertisement

Panel Doors
To open the rear panel doors, you must open the
passtnger's side door first. If the door is locked, insert
your door key in the lock and turn it counterclockwise to
unlock it.
To open the passenger's side door, pull up on the handle
and pull the door open.
To open the driver's side door, first open the passenger's
side door. Then, pull the handle on the left door edge out
and pull the door open.
The rear doors have a check assembly to keep them
from fully opening during normal use.
To fully open either rear door, you must release the
check strap. To release the check strap just:
1. Open the door partway until the white mark on the
check strap is fully outside the door edge. If the end
of the strap catches the pin on the door, the door is
open too far.
2. Then, hold the strap at
the white mark, pull the
strap toward you and
open the door all
the way.
To re-engage the door check strap, just close the door
and the strap will catch the pin.
To close the doors, close the driver's side door first.
After securely closing the door, close the passenger's
side door. Make sure both doors are latched securely.
To lock the rear doors from outside the vehicle, put your
key in the lock and turn it clockwise. If you have power
door locks, you can lock the side doors as well as the
rear doors from inside the vehicle. For more
information, see "Power Door Locks" in this section.
2-10

Advertisement

Table of Contents
loading

This manual is also suitable for:

1997 suburban

Table of Contents