Observe And Obey; Before Starting Installation; Tools Required; Glossary Of Terms - Terex Genie GS-3232 Installation Instructions Manual

Instructions
Introduction
Introduction
Introduction

Observe and Obey:


This procedure shall be completed by a person
trained and qualified on the repair of this
machine.

Immediately tag and remove from service a
damaged or malfunctioning machine.

Repair any machine damage or malfunction
before operating the machine.

Before Starting Installation:


Read, understand and obey the safety rules
and operating instructions in the appropriate
operator's manual.

Be sure that all necessary tools and parts are
available and ready for use.

Read this procedure completely and adhere to
the instructions. Attempting shortcuts may
produce hazardous conditions.
Indicates that a specific result is expected after
performing a series of steps.
Indicates than an incorrect result has occurred
after performing a series of steps.
Note: These installation instructions only apply
to the Genie models listed below, as required
by Safety Notice 120013.

GS-3232

GS-3246
2

Tools Required:

Laptop or desktop computer with an Ethernet Port
and Internet Browser
Torx T10 screw driver
CAT5 Ethernet cable of suitable length

Glossary of Terms

ECM - Electronic Control Module
GCON - Ground Controller. This ECM is located at
the ground controls.
PCON - Platform Controller. This ECM is located at
the platform controls.
CAT5 Cable - Standard Ethernet cable used for
networking purposes.
Components of Kit 219268
SmartLink Software Update Installation Instructions
Genie part number 219267
Qty. 1
Thumb drive
Genie part number 219205
Qty. 1
Includes:
Software SL1000, APP
Genie part number 137641
Qty. 1
SmartLink Software Update
Rev C
Part No. 219267