Chevrolet 1995 Blazer Owner's Manual page 96

To
Resume a Set Speed
Suppose
you set your Cruise Control at a
desired speed and then you apply
the brake. This, of course, shuts off the Cruise Control. But you don't need
Once you're going
about 25 mph (40
k d h ) or more, you
can move the Cruise
Control switch from
QN to R/A
(Resume/Accelerate)
for about half a
second.
You'll go right back up to your chosen speed and stay there.
Remember, if you hold the switch at R/A (Resume/Accelerate) longer than
half a second, the vehicle will keep going faster until you release the switch
or apply the brake. You could be startled and even lose control. So unless
you want to go faster, don't hold the switch at R/A (Resume/Accelerate).
To Increase Speed While Using
Cruise
Control
There are two ways to go to a higher speed.
1. Use the accelerator pedal to get to the higher speed. Push the button at
the end of the lever, then release the button and the accelerator pedal.
You'll now cruise at the higher speed.
2-44