Gate Operator And Canadian Programming - Cadillac 2005 STS Owner's Manual

5. Press and hold the newly-trained HomeLink
and observe the indicator light.
If the indicator light stays on constantly,
programming is complete and your device should
activate when the HomeLink
and released.
To program the remaining two HomeLink
begin with Step 2 under "Programming HomeLink
Do not repeat Step 1 as this will erase all of the
programmed channels.
If the indicator light blinks rapidly for two seconds
and then turns to a constant light, continue with
Steps 6 through 8 following to complete the
programming of a rolling-code equipped device
(most commonly, a garage door opener).
6. Locate in the garage, the garage door opener
receiver (motor-head unit). Locate the "Learn"
or "Smart" button. This can usually be found where
the hanging antenna wire is attached to the
motor-head unit.
7. Firmly press and release the "Learn" or "Smart"
button. The name and color of the button may
vary by manufacturer.
You will have 30 seconds to start Step 8.
®
button
®
button is pressed
®
buttons,
®
."
8. Return to the vehicle. Firmly press and hold the
programmed HomeLink
then release. Repeat the press/hold/release
sequence a second time, and depending on the
brand of the garage door opener (or other rolling
code device), repeat this sequence a third time
to complete the programming.
®
HomeLink should now activate your rolling-code
equipped device.
To program the remaining two HomeLink
begin with Step 2 of "Programming HomeLink
not want to repeat step 1, as this will erase all previous
programming.
Gate Operator and Canadian
Programming
Canadian radio-frequency laws require transmitter
signals to "time out" or quit after several seconds of
transmission. This may not be long enough for
®
HomeLink to pick up the signal during programming.
Similarly, some U.S. gate operators are manufactured to
"time out" in the same manner.
®
button for two seconds,
®
buttons,
®
." You do
2-43