Table of Contents
Advertisement
Gate Operator and Canadian
Programming
Canadian radio-frequency laws require transmitter
signals to "time out" or quit after several seconds of
transmission. This may not be long enough for
®
HomeLink
to pick up the signal during programming.
Similarly, some U.S. gate operators are manufactured to
"time out" in the same manner.
If you live in Canada, or you are having difficulty
programming a gate operator by using the
"Programming HomeLink
where you live), replace Step 3 under "Programming
®
HomeLink
" with the following:
Continue to press and hold the HomeLink
you press and release every two seconds (cycle)
your hand-held transmitter until the frequency signal has
been successfully accepted by HomeLink
indicator light will flash slowly at first and then rapidly.
Proceed with Step 4 under "Programming HomeLink
to complete.
®
Using HomeLink
Press and hold the appropriate HomeLink
least half of a second. The indicator light will come
on while the signal is being transmitted.
®
" procedures (regardless of
®
button while
®
. The
®
button for at
Erasing HomeLink
To erase programming from the three buttons do the
following:
1. Press and hold down the two outside buttons until
the indicator light begins to flash, after 20 seconds.
2. Release both buttons. Do not hold for longer than
30 seconds.
®
HomeLink
is now in the train (learning) mode and can
be programmed at any time beginning with Step 2
under "Programming HomeLink
Individual buttons can not be erased, but they can be
reprogrammed. See "Reprogramming a Single
®
HomeLink
Button" next.
Reprogramming a Single HomeLink
Button
To program a device to HomeLink
®
"
button previously trained, follow these steps:
1. Press and hold the desired HomeLink
not release the button.
2. The indicator light will begin to flash after
20 seconds. While still holding the HomeLink
button, proceed with Step 2 under "Programming
®
HomeLink
."
®
Buttons
®
."
®
using a HomeLink
®
button. Do
®
®
®
2-51
Advertisement
Chapters
Table of Contents
