Maintenance - King Canada KC-5006R Instruction Manual

MAINTENENCE
WARNING: For your own safety, turn switch "OFF" and remove plug from power source outlet before maintaining or lubricating your saw.
Do not allow saw dust to accumulate inside the saw. Frequently blow out any dust that may accumulate inside the saw cabinet and the motor.
Clean your cutting tools with a Gum and Pitch Remover. The cord and tool should be wiped with a dry clean cloth to prevent deterioration
from oil and grease.
WARNING: Certain cleaning agents and solvents can damage plastic parts. Some of these are: gasoline, carbon tetrachloride, chlorinated
cleaning solvents, ammonia and household detergents which contain ammonia. Avoiding use of these and other types of cleaning agents
will minimize the possibility of damage.
A coat of automobile type wax applied to the table will help keep the surface clean and allow workpieces to slide more freely.
If the power cord is worn or cut, or damaged in any way, have it replaced immediately.
WARNING: All repairs, electrical or mechanical, should be attempted only by trained repairmen. Contact the nearest King Canada Service
Center. Use only identical replacement parts, any other may create a hazard.
LUBRICATION
The gear case has been completely lubricated at the factory. However, after six months to one year, depending on use, it is wise to return
your tool to the nearest Service Center for the following:
• Brushes replaced
• Parts cleaned and inspected
• Relubricated with fresh lubricant
• Electrical system tested
• All repairs
The following parts should be oiled occasionally with SAE No. 20 or No. 30 oil, or WD40.
1. Elevation, support rods, and gears.
PARTS DIAGRAM & PARTS LISTS
Refer to the Parts section of the King Canada web site for the most updated parts diagram and parts list.

MAINTENANCE