Related Manuals for King Canada KC-3010NB
Summary of Contents for King Canada KC-3010NB
- Page 1 10” SLIDING TILE SAW WITH LASER GUIDE • Enhanced laser effect MODEL: KC-3010NB INSTRUCTION MANUAL COPYRIGHT © 2009 ALL RIGHTS RESERVED BY KING CANADA TOOLS INC.
-
Page 2: Warranty Information
LIMITED TOOL WARRANTY King Canada makes every effort to ensure that this product meets high quality and durability standards. King Canada warrants to the original retail consumer a 2-year limited warranty as of the date the product was purchased at retail and that each product is free from defects in materials. -
Page 3: General Safety Instructions
GENERAL SAFETY INSTRUCTIONS VOLTAGE WARNING: Before connecting the tool to a power source (receptacle, outlet, etc.) be sure the voltage supplied is the same as that specified on the nameplate of the tool. A power source with voltage greater than that for the specified tool can result in SERIOUS INJURY to the user - as well as damage to the tool. - Page 4 14. Keep your work space clear and free of all debris. 15. Keep the tile saw clean and maintained to achieve the safest and highest performance for each job. KEEP THESE SAFETY RULES FOR FUTURE REFERENCE TILE SAW SPECIFICATIONS Model....................................KC-3010NB Voltage ......................................120V Horsepower ....................................2.5 HP Amperage ....................................15 Amp.
-
Page 5: Electrical Connections
ELECTRICAL CONNECTIONS WARNING! ALL ELECTRICAL CONNECTIONS MUST BE DONE BY A QUALIFIED ELECTRICIAN. FAILURE TO COMPLY MAY RESULT IN SERIOUS INJURY! ALL ADJUSTMENTS OR REPAIRS MUST BE DONE WITH THE TILE SAW DISCONNECTED FROM THE POWER SOURCE. FAILURE TO COMPLY MAY RESULT IN SERIOUS INJURY! POWER SUPPLY 120V GROUNDED OUTLET WARNING: YOUR TILE SAW MUST BE CONNECTED TO A 120V,... - Page 6 ASSEMBLY UNPACKING, ASSEMBLY & SET UP Caution: Follow all of the assembly & installation instructions completely before connecting the tile saw to a power source or turning the motor on. Carefully open the main box and remove all the saw components and packing materials.
-
Page 7: Operation
OPERATION Once your sliding tile saw is completely assembled, we suggest to get the water tray and laser guide set up properly before attempting to operate. WATER PUMP/WATER SUPPLY Warning! To prevent excessive wear on the blade, make sure to maintain a continuous flow of water on the blade during all operations. - Page 8 1/2” deflection in the belt using light finger pressure. Make sure to retighten the 4 nuts (C). PARTS DIAGRAM & PARTS LISTS Figure 13 Refer to the Parts section of the King Canada web site for the most updated parts diagram and parts list.