Programming The Remote Control - Sony KDP-51WS550 Primary Operating Instructions Manual

Programming the Remote Control

MUTING SLEEP SAT/CABLE POWER
TV/VCR
VCR/DVD
SYSTEM
OFF
i.LINK
MTS/SAP
SELECT
DISC MENU MENU
INDEX
MUTING SLEEP SAT/CABLE POWER
FUNCTION
SAT/CABLE
i.LINK TV
TV/VIDEO ANT PIC MODE
ENTER
FLIP OPEN
INDEX
MENU
VOL CH
MODE
PALETTE
DRC
RESET DISPLAY
FAVORITES GUIDE
CODE SET
JUMP
3
FREEZE EXIT
TV
RM-Y192
The remote control is preset to operate Sony brand video equipment.
Sony Equipment
i.LINK
8 mm VCR
VHS VCR
DVD player
If you have video equipment other than Sony brand that you want to
control with the TV's remote control, use the following procedure to
2
program the remote control.
✍
The equipment must have infrared (IR) remote capability in order to be used
with the remote control.
1
Turn to the list of "Manufacturer's Codes" on page 50, and find
the three-digit code number for the manufacturer of your
equipment. (If more than one code number is listed, use the
number listed first.)
2
Open the remote control and set the A/V slide switch to
, , or
AV2 AV3 DVD
✍
If the device that you wish to program is connected through i.LINK, you
must set the slide switch to AV1.
3
Press
CODE SET.
4
Enter the three-digit manufacturer's code number.
5
Press .
ENTER
✍
You must do step 5 within 10 seconds of step 4, or you must redo
5
steps 3 through 5.
6
To check if the code number works, aim the TV's remote control
at the equipment and press the
with that equipment. If it responds, you are done. If not, try using
another code listed for that manufacturer.
Notes
❑
If more than one code number is listed, try entering them one by
one until you come to the correct code for your equipment.
❑
If you enter a new code number, the code number you previously
entered at that setting is erased.
❑
In some cases, you may not be able to operate your equipment
with the supplied remote control. In such cases, use the
equipment's own remote control unit.
❑
Whenever you remove the batteries to replace them, the code
numbers may revert to the factory setting and must be reset.
Switch Position on
Remote Control
i.LINK/AV1
AV2
AV3
DVD
. Then close the remote control.
POWER
Programmable Code
Number
901
302
301
751
i.LINK/AV1
button that corresponds
,
49