Satellite Receiver And Vcr - Sony KDP-51WS550 Primary Operating Instructions Manual

Satellite Receiver
and VCR
Using
S VIDEO jacks?
See page 23.
Notes on Using This Connection
To Do This ...
Watch the satellite receiver
Watch the VCR
Set up the TV remote control
to operate the satellite
receiver or VCR
Activate the TV remote
control to operate the satellite
receiver or VCR
Control satellite receiver and
VCR functions with the TV
remote control
Label video inputs to easily
identify equipment connected
to the TV
32
To connect a satellite receiver and VCR
1
Connect the satellite antenna cable to the satellite receiver's
satellite input jack.
2
Connect the CATV cable to the VCR's VHF/UHF input jack.
3
Use a coaxial cable to connect the VCR's VHF/UHF output jack
to the TV's CABLE jack.
4
Use an A/V cable to connect the satellite receiver's A/V output
jacks to the VCR's A/V input jacks.
5
Use an A/V cable to connect the VCR's A/V output jacks to the
TV's A/V input jacks.
6
Run the Auto Setup program, as described in "Setting Up the
Channel List" on page 41.
Do This ...
Press TV/VIDEO repeatedly to select the VCR input (VIDEO 1 in the
illustration).
The VCR may need to be turned on and set to the satellite receiver input.
TV/VIDEO
Press repeatedly to select the input to which the VCR is connected
(VIDEO 1 in the illustration).
If you have a non-Sony VCR or satellite receiver, you must program the
remote control. See "Programming the Remote Control" on pages 49-50.
For the satellite receiver, press
outside cover, as shown on page 48. Then set the A/V slide switch to the
position you programmed for the VCR.
See "Operating a Satellite Receiver" on page 51 and "Operating a VCR" on
page 51.
See the instructions for setting up Video Labels on pages 103-104.
SAT/CABLE FUNCTION. For the VCR, open the