Table of Contents
Advertisement
3. Return to the universal transmitter
in
your vehicle and
press the universal transmitter button you have already
programmed for two to three seconds. Press the button
again to make sure that the universal transmitter has
been trained to the garage door opener receiver. Check
that the training
was
successful. The receiver light
should no longer be flashing.
The garage door opener should now recognize the
universal transmitter. You may either use the universal
transmitter or the hand-held transmitter to open the
garage door.
If after following these instructions you still have
problems training the garage door opener, consult
your dealer.
Erasing Channels
To erase all three programmed channels, hold down the
two outside buttons until the indicator light begins to
flash. Individual channels cannot be erased, but can be
reprogrammed using the procedure for programming the
transmitter explained earlier.
Accessories
Accessories for the universal transmitter are available
from the manufacturer of the unit. If you would like
additional information, please call 1-800-355-35 15.
2-59
Advertisement
Table of Contents
