Advertisement
The display will show either 3 or 4 digits and the preset button "LED"
will flash. In the farthest right position of the display will be an "F"
(for factory setting), or if the equalization has been modified, a "U"
(for user setting).
Press the
SCAN
switch up or down to select the band you prefer.
The middle digit indicates the equalization band. There are five bands
60Hz, 250Hz, lkHz, 3.5Hz and lOkHz, numbered 1 through 5
respectively. The band will display band 1 when the mode is first entered.
Press the SEEK switch up or down to select the gain setting you want.
The left digit, or two digits are the equalization gain settings (0-15) for
each band. The display will indicate the active setting (F or U) when
the mode is first entered. A typical setting for a flat response is 7.
0
Press the upper radio knob to compare the factory setting to your
setting. Once you are satisfied with your selection, press and hold the
preset equalization button for about 4 seconds, the" Pr" (program)
will display indicating that your selection is programmed.
If you have programmed the preset equalization buttons and set the push
buttons to the stations you've selected, you can preset the five Preset
Equalization buttons to a particular station. Just:
Tune in a station using one of the preset push buttons.
157
Advertisement
