Advertisement
made especially for your automatic transaxle. Damage caused by fluid
other than DEXRON@-IIE is not covered by your new vehicle warranty.
After adding fluid, recheck the fluid level as described under
"How
to
Check."
When the correct fluid level is obtained, push the dipstick back in all
How To Reset Transaxle Fluid Change Indicator: (4.6 Liter Northstar)
Your vehicle is equipped with a transaxle fluid change indicator. A
"CHANGE TRANS FLUID'' message will display on the Information
Center when the power train computer determines that the transaxle
fluid needs to be changed or at each 100,000 miles (160,000 km) interval,
whichever occurs first. When this message appears, change the transaxle
fluid and reset the transaxle fluid life indicator as follows:
the way.
0
Turn the key "ON" with the engine stopped.
Press and hold the "OFF" and "REAR DEFOG" buttons on the
climate control simultaneously until the "TRANS FLUID RESET"
message appears
in
the Information Center (between
5
and 20
seconds).
ENGINE COOLANT
The following explains your cooling system and how to add coolant when
it
is low.
If you have a problem with engine overheating, see "Engine
Overheating" in the Index.
The proper coolant for your Cadillac will:
Give freezing protection down to -34" F (-37" C)
.
0
Give boiling protection up to 262OF (128O C)
.
0
Protect against rust and corrosion.
Help keep the proper engine temperature.
Let the warning lights work as they should.
What to Use:
Use a mixture of one-half clean water (preferably distilled) and one-half
antifreeze that meets "GM Specification 1825-M,"
which won't damage
aluminum parts. You can also use a recycled coolant conforming to GM
280
Advertisement
