Interruption Of Work; Taking Out Of Operation And Cleaning - WAGNER WallPerfect Flexio 580 I-Spray Manual

Flexio 580 I-Spray
"Cross spray" when using paint with a poor covering capacity or if the
i
surface is highly absorbent (Fig. 11).
•
I nterior wall paint in strong colour shades should be applied at least twice (allow first
paint coat to dry first). This will ensure good coverage.

16. interruption of Work

•
T urn the machine off.
•
D uring longer breaks, vent the container by briefly opening and then closing it again.
•
C lean nozzle openings after an interruption in operation.
•
W hen processing 2-component varnishes, clean the device immediately.

17. taking out of operation and Cleaning

proper cleaning is the prerequisite for problem-free operation of the paint application
device. no warranty claims are accepted in case of improper or no cleaning.
never hold the spray gun rear part under water or immerse it into liquids.
Clean the housing only with a moistened cloth.
1) Unplug the power plug. Vent the container in case of longer breaks and after the work
has been terminated. This can be done by briefly turning open and then closing the
container or by pulling the trigger guard and letting the paint into the original paint
container.
2) Divide the spray gun. Press the hook (Fig. 3 b "click") slightly downwards. Turn the gun
front part and gun rear part against each other and take them apart.
3) Unscrew the container. Empty any remaining coating material back into the material
tin.
4) Preclean the container and feed tube with a brush. Clean the ventilating bore (Fig. 12, 1).
5) Pour water or solvent into the container. Screw the container back on.
Do not use flammable materials for cleaning purposes.
6) Assemble the gun again (Fig. 3).
7) Insert the power plug, turn on the machine and spray the water or solvent into a
container or a cloth.
8) Repeat the above procedure until the water or solvent emerging from the nozzle is
clear.
9) Turn off the machine and remove the plug.
10) Divide the spray gun. Press the hook (Fig. 3 b "click") slightly downwards. Turn the gun
front part and gun rear part against each other and take them apart.
GB
49