Headlamp High/Low-Beam Changer; Flash-To-Pass; Windshield Wipers - Buick 2007 LaCrosse Owner's Manual

Headlamp High/Low-Beam Changer

To change the headlamps from low beam to
high beam, push the turn signal/multifunction
lever away from you.
To change the headlamps from high beam to low
beam, pull the turn signal lever toward you.

Flash-to-Pass

This feature lets you use your high-beam
headlamps momentarily to signal a driver in
front of you that you want to pass.
To use it, pull the turn signal/multifunction lever
toward you until the high-beam headlamps
come on, then release the lever to turn them off.
When the high beams
are on, a light on the
instrument panel cluster
also will be on if the
ignition is on.

Windshield Wipers

Be sure to clear ice and snow from the wiper
blades before using them. If they are frozen to the
windshield, gently loosen or thaw them. Damaged
wiper blades may not clear the windshield well,
making it harder to see and drive safely. If the
blades do become damaged, install new blades or
blade inserts. For more information, see Windshield
Wiper Blade Replacement on page 401.
Heavy snow or ice can overload the wiper motor. A
circuit breaker will stop the motor until it cools down.
Clear away snow or ice to prevent an overload.
You control the windshield wipers by turning the
band with the wiper symbol on it.
(Mist): For a single wiping cycle, turn the
8
band to mist. Hold it there until the wipers
start. Then let go. The wipers will stop after
one wipe. If you want more wipe cycles, hold
the band on mist longer.
153