Charging The Dog Collar Device; Turning On The Device; Turning Off The Device; Selecting A Language - Garmin ALPHA 10 Owner's Manual

Charging the Dog Collar Device

NOTICE
To prevent corrosion, thoroughly dry the contacts on the collar and the surrounding area before connecting the
charging clip.
NOTE: Your dog collar device may look different than the device pictured.
You should fully charge the battery before you use the device for the first time. Charging a fully depleted battery
takes about five hours.
1 Snap the charging clip onto the device .
2 Plug the small end of the power cable into the mini-USB port on the charging clip cable.
3 Plug the power cable into a power source.
The status LED is solid red when the collar is charging.
4 After the status LED turns solid green, remove the charging clip from the collar.

Turning On the Device

• On the handheld device, press the power button.
• On the dog collar device, hold the power button until the status LED flashes and the collar beeps.

Turning Off the Device

• On the handheld device, hold the power button and select Power Off.
• On the dog collar device, hold the power button until the status LED turns red.

Selecting a Language

When you turn on your device for the first time, you must select the device language from a list of available
languages. You can change the language setting from the System settings.
1 Press the menu button.
2 Select Setup > System > Language.
3 Select a language.
Getting Started 5