Reprogramming a Single HomeLink
Button
To program a device to HomeLink
button previously trained, follow these steps:
1. Press and hold the desired HomeLink
not release the button.
2. The indicator light will begin to flash after
20 seconds. While still holding the HomeLink
button, proceed with Step 2 under "Programming
®
HomeLink
" shown earlier in this section.
For questions or comments, contact HomeLink
1-800-355-3515, or on the internet at
www.homelink.com.
Storage Areas
Glove Box
To open the glove box, lift up on the lever. The glove
box has a light inside and a shelf for storing manuals.
The shelf is located at the top of the glove box.
2-40
®
®
®
using a HomeLink
®
button. Do
®
®
at
Cupholder(s)
Your vehicle has cupholders in the rear seat
armrest.
If your vehicle has the
five-passenger console,
there is a cupholder in front
of the center console. The
cupholder has an arm that
adjusts to two positions to
fit either a large cup or
two smaller cups.
If your vehicle has the
six-passenger console, a
front console cupholder
is accessible by turning the
bottom of the armrest/seat
forward.