Table of Contents
Advertisement
Chapter 15
Calibrate touchscreen
If you notice that the WireScope 350 is misinterpreting your screen touches (i.e.
entering the value of the key adjacent to the one you are trying to press), then
you may need to calibrate the touchscreen to bring it into alignment with the
underlying display.
Please be sure that you have the stylus that was supplied with the WireScope
350 before you attempt to calibrate the touchscreen. Calibrating the touchscreen
with a larger pointing device (such as your fingertip) may degrade the alignment
of the touchscreen calibration.
Select Calibrate Touchscreen from the system Settings Screen and press
or the Edit button. The following screens will appear:
1
3
Touch the indicated corner of each screen with the tip of the stylus, being
careful to touch as close to the corner as possible. After each successful touch is
registered, the hand icon will move to the next corner and continue this process
until the touchscreen calibration process is complete.
2
4
WireScope 350 System Settings 131
Advertisement
Table of Contents
