Table of Contents
Advertisement
Griplate™
1.
The Griplate™ have M4, M5, M6 and M8 hole patterns to fit the hardware that the flat panel requires.
Example:
If your display uses M8 x 20 Phillips head screws. Use the M8 mounting points (Figure 5).
Dimples
2.
Once the mounting brackets are aligned, secure the Griplate™ to the flat panel.
NOTE:
The dimples of the top plates have to be facing up and the bottom dimples must be facing down. Use
(1) Griplate™ per mounting point (Figure 6).
CAUTION: Do not over tighten the mounting hardware.
Phillips Screw
Driver
Installation Manual
Figure 5. Griplate™ Orientation
DIMPLES
FACING UP
3/4"
Figure 6. Griplate™ Attachment
DIMPLES
FACING UP
DIMPLES
FACING DOWN
DIMPLES
FACING DOWN
M8
M6
M5
M4
Bottom Flat Panel
Page - 7 -
SFM3
Advertisement
Table of Contents
