Garmin GFC 600 Manual page 26

Installed in piper pa46-310p/350p
Hide thumbs Also See for GFC 600:
Table of Contents

Advertisement

GO AROUND (GA)
1.
Control
Wheel ............................................................................................................... GRASP FIRMLY
2. GO AROUND button ................................................................ PRESS – VERIFY GA / GA on GMC 605
3. Autopilot ........................................ VERIFY airplane pitches up following flight director command bars
4. Power.............................................................................................APPLY Go Around power
5. GMC 605 Mode Panel ......................................... PRESS NAV to couple to selected navigation source
6. Altitude Preselect (if installed) .......................................................... VERIFY Set to appropriate altitude
The pilot is responsible for initial missed approach guidance in accordance with
published procedure. When the GA button is pressed the Flight Director command bars
will command go-around pitch attitude and wings level. The pilot must select the CDI to
the appropriate navigation source and select the desired lateral and vertical flight director
modes.
VERTICAL NAVIGATION (VNV)
(Optional Feature)
1. Navigation Source ................................................................................................ SELECT CDI to GPS
2. Vertical Navigation Profile ......................................................... LOAD into the GPS navigator flight plan
3. Altitude Preselect................................................ADJUST to desired altitude below current altitude
4. GMC 605 VNV Key....................................................................................................PRESS
5. Bold or subdued font VPTH annunciation............................................................. VERIFY on GMC 605
If the altitude preselect is not set at least 75 FT below the current aircraft altitude, the
autopilot will not capture the vertical navigation path.
The autopilot will capture the vertical navigation path from above or below.
GFC 600 Autopilot Installed in Piper PA-46-310P/350P
Page 26 of 46
PRESS HDG to Fly ATC Assigned Missed Approach Heading
NOTE
(VERIFY aircraft flight path will intercept the vertical navigation profile)
NOTE
autopilot will not disengage
OR;
190-02011-11 Rev. 2

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents