Finish The Installation - Kohler Sterling 6104 Series Installation Manual

Complete the Plumbing Installation (cont.)
Close the valves.
Close or plug the bottom drain.
Run the water to fill the bath to the overflow.
Check all drain connections for leaks. Repair if necessary.
Close the valves and drain the bath.

11. Finish the Installation

Install Optional Shower Door
Install the shower door according to the manufacturer's instructions.
Install Other Accessories
CAUTION: Risk of property damage. Do not make additional holes in the wall surround or bath
without adding adequate sealant. Holes made to install any accessories may cause leakage. The
improper installation of accessories may void the warranty.
NOTE: For installations with wall surrounds, install the shower curtain rod above the top of the wall
surrounds.
Install any accessories according to the manufacturer's instructions.
Verify that any holes in the finished wall are properly sealed.
When construction is completed, check for leaks.
12. Clean Up
CAUTION: Risk of product damage. Do not use abrasive cleaners.
CAUTION: Risk of product damage. Do not use any acid-based cleaners on fixtures made of Vikrell
Wipe your bath with a soft cloth after each use to prevent a build-up of soap and scum.
Sterling recommends the following products for regular (weekly) cleaning: Spic and Span®, Top
Job , Fantastik , Mr. Clean
® ®
Avoid cleaning products that contain acetone, ethyl alcohol, amyl or ethyl acetate, sodium
hypochlorite, toluene, or phenol. These products can damage the finish.
Extreme heat such as that generated by cigarettes or portable heaters can damage Vikrell surfaces.
Do not use such items near your bath.
1020583-2-D
, or Glass Plus .
® ®
14
.
TM
Sterling