Table of Contents
Advertisement
SVMASTER -
NEUTRAL START SAFETY TEST:
2. Block the drive wheels to prevent vehicle movement.
3.
Sitting in the vehicle, turn the ignition switch to "ON" or "RUN" position. But do not start the
engine.
4. Step on the brake pedal and shift the gear selector into "DRIVE (D).
5. Put your foot over the brake pedal but do not press down on it. Be ready to step on the brake
to shut down the Remote Start Device.
6. Start the vehicle using remote transmitter.
a. If the starter does not engage, the test is complete.
b. If the starter engages, immediately step on the brake pedal to shut down the system,
recheck your VIOLET wire (H1/1 starter output wire) connection. The heavy gauge VIOLET
wire must be connected to the ignition switch side of the Neutral Start Switch. If the vehicle
you are working on does not have an Electrical Neutral Safety Switch, it will be necessary
to reconfigure the Remote Starts Wiring to accommodate this vehicle. The information
concerning the Mechanical Neutral Safety Switch provided below will help you to determine
if the vehicle you are working on has this type of safety switch and will provide alternate
wiring methods to accommodate this situation.
PARWNEUTRAL ECM INPUT:
The ParWNeutral ECM input is the preferred method of installation. This not only maintains the
integrity of the factory circuit, it is also the easiest to install, providing the vehicle you are working
on has this ECM input.
The installation required for this application (shown below), indicates in the slight reconfiguration
of the control switch wiring. Shown is a typical GM ParMNeutral ECM input circuit. To connect
the Remote Start unit to the GM ParWNeutral ECM input:
1.
Locate the Orange/Black reference wire in
Body vehicles or, locate the equivalent reference wire in the vehicle you are installing the
Remote Start Unit in.
2.
Connect the B L A C W H I T E Neutral Safety Switch wire (H6/2) to this reference wire.
NOTE: If the optional remote starts enable toggle switch is installed, connect the one side the
enable switch to this reference wire and connect the other side of the enable switch to the
The reference diagram below shows a typical GM B Body ECM reference wire and how it is to
Optional Enable Switch
To Neutral Safety
SVMASTER -
the
" C 2 connector found at the ECM in GM B
............................................
..........................
23
http://www.msvmaster.lv
-
Electronic Control Module (ECM)
Solid State, Do Not Measure
Resistance
http://www.msvmaster.lv
-
Advertisement
Table of Contents
