Shutdown Diagnostics; Testing Your Installation - Autopage RS-750lcd Installation Manual

SVMASTER -
The unit has the ability to report the cause of the last shutdown of the remote start system.
Enter:
Turn the Ignition 'switch to 'ON position.
2.
Press the button on the transmitter.
The LED will now report the last system shutdown by flashing
3.
Shutdown Mode
Flashes
(-) Safety Shutdown input (Hood)
Neutral Safety Switch input fail.
3 No RPM or Low Voltage.
4 (-) Wait for Start timed out
5 Over-rev
6 System timed out
7 Transmitter

TESTING YOUR INSTALLATION:

Caution!! The follow procedure must be performed after the installation of the Remote Start
Device. It is the responsibility of the installing technician to complete these tests. Failure to test
the unit in the following manner may result in personal injury, property damage, or both.
1. Test the BRAKE shutdown circuit: With the vehicle in park
remote transmitter, Once the engine is running, press the brake pedal. The vehicle should
shut down immediately. If the vehicle continues to run, check the brake circuit WHITE/
VIOLET wire (H6/3) connection.
2. Test the HOOD PIN shutdown circuit: Start the vehicle using the remote transmitter, Once
the engine is running, pull the hood release and raise the hood. The vehicle should shut
down immediately. If the vehicle continues to run, check the hood pin WHITE/ BLACK wire
SVMASTER -

SHUTDOWN DIAGNOSTICS

2. Check H6/1 White/ Black wire connection.
2. Move the Enable Toggle Switch to "ON"
3. Move the gear selector to "Park/
4. Check H6/2 BlacWhite wire connection.
TACHOMETER CHECKING TYPE:
Check H6/8 White/Red wire connection
VOLTAGE CHECKING TYPE:
Program the "CHECK LEVEL" from
"Hi Check Level" to "Low Check Level"
1. Check wait for start indicator
2. Check H6/5 White/ Green connection.
22
http://www.msvmaster.lv
-
for
one minute in the
position. (If installed.)
"NEUTRAL" position.
(P), start the vehicle using the
http://www.msvmaster.lv
-