Panasonic EB-X300 Service Manual page 61

Dummy Battery (Part No. 3WZ001126AAA)
The dummy battery provides the interface to supply power via power cable. It has been contoured to allow the RF Cable to be
connected to the handset RF test socket at the same time.
Figure 7.4. : Dummy Battery
PCB Repair Jig (3WZ001129AAA )
The PCB Repair Jig provides the necessary connections between the PCB Assembly and external test equipment. It is required
for RF calibration.
Figure 7.5. : PCB Repair Jig
GSM Tester
This unit acts as a base station providing all the necessary GSM signalling requirements and also provides GSM
signal-measuring facilities..
Calibration Software
This is the test software for the telephone unit and should be installed onto the personal computer to be used for testing.
T5 Screwdriver
This screwdriver is required to remove the case screws from the phone.
– 7-3 –