Display Description - Vision Fitness T1450 Engineering Manual

T1450 (TM239): Engineering Guide
ENG 5: SPEED SENSOR MODE
The PWM value is displayed in the middle window. The Elevation A/D is displayed in the left window. The Dot
Matrix displays a flashing row of lights between 2 constant rows of lights. As the
flashing row will flash quicker, indicating a faster PWM.
ENG 6: EXIT ENGINEERING
ERROR MESSAGES
Three types of errors can occur; speed, elevation, and EEPROM software error. All three use the same display to indicate
the error, with the error number appearing in the main window. An elevation error shuts down the treadmill and disables
normal operation. A speed sensor error also shuts down the treadmill. The user, however, can enter engineering mode
after an error announcement.
ERROR

DISPLAY DESCRIPTION

Elevation E4 Current elevation position is outside
Range zero and max elevation values
Elevation E4 Current elevation position has not
Stall reached target incline
Elevation E6 No elevation signal reading or elevation
Lost motor is not connected.
Over speed E7 Speed of the belt differs from the
calibrated max speed by 1.0 mph or
km/h as measured by the speed sensor
No Speed E9 No speed is detected during
Feedback Auto-Calibration
SAFETY SWITCH
If the safety magnet disconnects from the console, the treadmill shuts down if in run mode. The treadmill displays " " - - - - - - - - " " in
the main window. This is a safety precaution to warn the user that power is still being applied to the board. This safety
switch condition occurs in any mode, including engineering modes.
When the magnet reconnects to the console, the board resets. Any activity or run time information prior to the reconnection
will be lost.
Date of last revision: 10.06
"SPEED UP"
SOLUTION
Enter ENG 1 and manually position elevation within
the min and max values. If not possible, recalibrate
min and max elevation
Check for bad cable connection. Check for connection
between motor controller and elevation motor as well
as any obstruction to the elevation. Try to reboot system
Check for bad cable connection. Check for connection
between motor controller and elevation motor. Check
for bad elevation motor
Cycle power to clear error. Check speed sensor and
magnets as well as any obstruction to the rollers or
running belt. Recalibrate.
Check speed sensor cable, speed sensor and magnets
4
arrow is pressed the
TREADMILL.ENG.TM239.REV1