Table of Contents
Advertisement
Procedure – Installation (SSD)
IMPORTANT:
Replacing the SSD with a different volume may result in reduced system performance.
1.
Insert SSD – Insert the connector end of the SSD into the SSD connector on Main board at ~15 degree angle.
2. Install new SSD 3IP screw – Use a 3IP screwdriver to install a new SSD screw until the screw is just snug and
seated, and then turned another 45 degrees (1/8 turn) or until screw is fully fastened.
12
Only a Microsoft SSD of like capacity should be replaced in the device.
M1177096
Advertisement
Table of Contents
