Table of Contents
Advertisement
58/72
Commissioning
Bosch Rexroth AB, RE 15300-WA, Version 06.2021
8 Commissioning
Dirt particles!
A not run-in motor in combination with dirt particles in the oil can badly affect
the sliding surfaces in the motor. This is valid during the first 100 hours.
▶ The Hägglunds radial piston hydraulic motor must be installed and
commisioned in a clean condition.
8.1 Commissioning
Check the following points before commissioning the motor, i.e. before starting the
first time:
•
Make sure that all fluids has been removed from the motor to prevent
accidental mixing with the hydraulic fluid used in the system.
•
Check that the motor is installed according to chapter 7: Installation
•
Check that all hydraulic couplings and plugs are properly tightened to prevent
leakage.
•
Select the hydraulic fluid in accordance with the recommendations, See
chapter 15.1.1: Hydraulic fluids and Data sheet
reference.
8.1.1 Oil filling
1. Fill the motor housing with hydraulic fluid via a filter into the drain outlets D1 to
D8 or the vent hole (depending on how the motor is mounted), for oil volumes
see Table 6.
2. Check the drain line to ensure that excessive pressure does not build up in
the motor case; see chapter 7.2: Installation conditions
venting the motor
3. Check that the motor is protected from overloads, see chapter Motor data in
data sheet
RE
15300.
NOTICE
RE 15414 Hydraulic fluid quick
and:
7.4.6: Draining and
Advertisement
Table of Contents
