Table of Contents
Advertisement
3.
IDE connector (40-1 pin PRI_IDE1)
This connector is for an Ultra DMA 133/100/66 signal cable. The Ultra
DMA 133/100/66 signal cable has three connectors: a blue connector for
the primary IDE connector on the motherboard, a black connector for an
Ultra DMA 133/100/66 IDE slave device (optical drive/hard disk drive), and
a gray connector for an Ultra DMA 133/100/66 IDE master device (hard disk
drive). If you install two hard disk drives, you must configure the second drive
as a slave device by setting its jumper accordingly. Refer to the hard disk
documentation for the jumper settings.
•
•
If any device jumper is set as "Cable-Select," ensure that all other device
jumpers have the same setting.
2-24
Pin 20 on the IDE connector is removed to match the covered hole on the
Ultra DMA cable connector. This prevents incorrect insertion when you
connect the IDE cable.
Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.
Chapter 2: Hardware information
Advertisement
Table of Contents
