Required Equipment; Equipment Setup - Nokia NSW-6 Series Technical Documentation Manual

PAMS Technical Documentation

Required Equipment

– PC/AT computer with service software; see separate section for
instructions on installation and use.
– Service accessories; see equipment setup pictures.
– Multimeter or DVM.
– Measuring equipment as follows:

Equipment Setup

Caution: Make sure that you have switched off the PC and the printer
Caution: Do not connect the PKD–1 key to the serial port. You may
Attach the protection key PKD–1 to parallel port one (25–pin female
D–connector) of the PC. When connecting the PKD–1 to the parallel port
be sure that you insert the PC end of the PKD–1 to the PC (male side). If
you use a printer on parallel port one, place the PKD–1 between the PC
and your printer cable.
Next connect the M2BUS service cable, DAU–9S, to the serial port
(RS–232) of the computer. Attach one end of the service cable to the PC
serial port and the other end to the service box, JBU–8 or Flash Adapter
FLA-9.
When the phone covers are removed the jig JBS-25 must be used.
For audio measurements the audio box JBA-6 is used.
Warning: Do not use JBU–8 for tuning!
Issue 1 12/99
Tuning, Flashing and NAM programming instructions
– RF generator
– pulse power meter
– spectrum analyzer
– attenuator and branching unit
before making connections !
damage your PKD–1 !
E Nokia Mobile Phones Ltd.
NSW-6
Page 5