800Mhz Analog Tx Output Power; 800Mhz Digital Tx Output Power - Nokia NSW-6 Series Technical Documentation Manual

Hide thumbs Also See for NSW-6 Series:

Technical documentation manual (20 pages)

Disassembly & troubleshooting instructions (52 pages)

Technical documentation manual (68 pages)

Table Of Contents

Table of Contents

PAMS Technical Documentation

– –Settings for pulse power meter:

– –Select Tuning –> Using WinTesla Select Tuning –> TX power –>

LowBand/HighBand –>EEPROM values

– –All four tuning channels have to be tuned. Repeat tuning for A, B, C

and D tuning channel. Tuning channel change reads old tuning values

from phone's EEPROM.

– –Adjust power level by clicking the + and – buttons, power level

change is done by keyboard keys

– –Tune the power levels, which are shown by "# for calculate"

– –Press Calculate button to calculate other power levels.

– –Check tuning, Do fine tuning if needed.

– –Once all TX tuning channels are correct, press SAVE button

– –Tuning is done, if both Analog mode and 800 MHz and 1900 MHz

digital mode are tuned

There are different results when measuring TX power from the Test Pad

of panel or the Antenna Pad, It must be ensured that the measurements

from the Antenna Pad give correct results.