Download Print this page
Nokia NSE-5 Series Disassembly Instructions Manual

Nokia NSE-5 Series Disassembly Instructions Manual

Pams technical documentation
Hide thumbs Also See for NSE-5 Series:

Advertisement

Quick Links

PAMS Technical Documentation
NSE–5 Series Transceivers
Disassembly Instructions
Draft 0.4

Advertisement

loading

Summary of Contents for Nokia NSE-5 Series

  • Page 1 PAMS Technical Documentation NSE–5 Series Transceivers Disassembly Instructions Draft 0.4...
  • Page 2 PAMS NSE–5 Disassembly Instructions Technical Documentation [This page intentionally left blank] Page 2 Draft 0.4...
  • Page 3 PAMS NSE–5 Disassembly Instructions Technical Documentation 1.Remove the Battery 2. Remove Dust Cap 3. Remove the Screws (4x) 5. Pull out Antenna . Lift off B–Cover note: snap fitting note: snap fitting Page 3 Draft 0.4...
  • Page 4 PAMS NSE–5 Disassembly Instructions Technical Documentation 6. Remove the Screws (2x) 7. Lift off the PCB 8. Remove the Slide Sensor Switch 9. Pull out the Slide until the End Stop Page 4 Draft 0.4...
  • Page 5 PAMS NSE–5 Disassembly Instructions Technical Documentation 10. Use a pair of Tweezers to push the Slide Stopper Spring in the direction indicated. 11. Simulateously with step 10: Pull out the Slide past the End Stop ! note: Pull out straight ! Handling the Slide Assembly: ! DO NOT handle the Slide like this ! ALWAYS handle the slide like this.
  • Page 6 PAMS NSE–5 Disassembly Instructions Technical Documentation 12. Bend open one side of the (plastic) Slide Cover and take out the Metal Slide ! DO NOT ! ALWAYS Hold the Metal Slide like this. Handle the Metal Slide like this. The Metal Slide is bent very eas- The Metal Slide can be held by the Targa Bow or by one of ily when it is not protected by the the Plungers.
  • Page 7 PAMS NSE–5 Disassembly Instructions Technical Documentation 13. Remove the Display Assembly 14. Remove the Keymat Module 15. Remove the Speaker and the Roller Key Page 7 Draft 0.4...
  • Page 8 PAMS NSE–5 Disassembly Instructions Technical Documentation 16. ! Assemble the whole phone before fitting the Slide Assembly ! The remaining assembly is done in the reverse order of the disassembly. Note Torque for screws 0.2Nm 17. Position the right hand Plunger onto the start of the track and on the Microphone Connector, as shown 18.

This manual is also suitable for:

7110