Installation Procedure - Honeywell BENDIX KING KMH 880 System Installation Manual

B B
B B
If possible, clearance to the top of the KMH 820 should be provided to facilitate
removal and installation of the terrain database CompactFlash card. The terrain
database card is removed and installed with power NOT applied to the system.
The KMH 820 may be removed from the aircraft to extract and install database
cards if the mounting location does not provide enough clearance.
Updating the Terrain DataBase is accomplished by:
Moving the aluminum cover over the CompactFlash card out of the way.
Pressing the flash card ejector button located within the unit.
Removing the old flash card.
Inserting the new flash card and replacing the cover.
If possible, mount the KMH 820 such that the above can be accomplished without
requiring disassembly of the aircraft or removal of the KMH 820.
The KMH 820 drives three lamps and accepts input from two switches. The lamps
should be identified as:
FUNCTION
Not Available
Caution
Warning
The RED Warning lamp must be located in the pilot's primary field of view.
The EGPWS provides a single 600 ohm audio output which should be connected
to a un-switched/un-muted auxiliary audio input on the aircraft's audio control
panel. The audio output power level is set by programming the configuration mod-
ule.
2.2.3.3

Installation Procedure

A. Slide the unit into the rack and secure it.
B. Attach the harness to the front mating connector of the unit.
C. Attach coax cables J1 thru J10 to the front of the unit.
Page 2-4
COLOR
Amber Terrain N/A or Terr N/A
Amber Terrain
Red Terrain
10609I00.ZIPCDL
KMH 880/KTA 870
LEGEND
Rev 0, October/2000