Installation - Miele KM 6310 Operating And Installation Instructions

Installation

 Create the countertop cut-out.
Remember to maintain the minimum
safety distances (see "Installation" –
"Safety distances").
 Seal any cut surfaces on wooden
countertops with a special varnish,
silicone rubber, or resin to prevent the
wood from swelling as a result of
moisture. The sealant must be
temperature-resistant.
Ensure that the sealant does not get
on the top surface of the countertop.
 Attach the sealing strip provided
underneath the edge of the cooktop.
Do not apply the sealing strip under
tension.

Risk of damage from incorrect
connection.
The electronics of the cooktop may
be damaged if a short-circuit occurs.
The power cable must be connected
to the cooktop by a qualified
electrician.
 Connect the power cable to the
cooktop by following the instructions
in the wiring diagram (see
"Installation – Electrical connection").
 Feed the cooktop power cable down
through the cut-out in the countertop.
 Place the cooktop centrally in the
cut-out. When doing this, make sure
that the seal of the appliance sits
flush with the countertop on all sides.
This is important to ensure an
effective seal all round.
If the seal does not sit flush with the
countertop in the corners, the corner
radius (≤ R4) can be carefully cut to fit
using a jigsaw.
 Connect the cooktop to the electricity
supply (see "Installation – Electrical
connection").
 Check that the cooktop works.
Installation
61