Direct Tuning - Sony STR-DG910 Operating Instructions Manual

1
Press TUNER repeatedly to
select the FM or AM band.
2
Press TUNING + or TUNING –.
Press TUNING + to scan from low to
high; press TUNING – to scan from high
to low.
The receiver stops scanning whenever a
station is received.
Using the controls on the
receiver
Turn INPUT SELECTOR to select the FM
1
or AM band.
Press TUNING MODE repeatedly to select
2
"AUTO T.".
Turn TUNING +/–.
3
In case of poor FM stereo
reception
If the FM stereo reception is poor and "ST"
flashes on the display, select monaural audio
so that the sound will be less distorted.
• To select monaural audio, set "FM MODE"
in TUNER menu to "FM MONO" (page 53).
• To return to stereo mode, set "FM MODE"
in TUNER menu to "FM AUTO" (page 53).

Direct tuning

You can enter the frequency of a station
directly by using the numeric buttons.
SAT TV
AUX DMPORT
2CH A.F.D.
CATEGORY
SLEEP
MODE
1
3
4
7
- / --
0/10
CLEAR
>10
1
Press TUNER repeatedly to
select the FM or AM band.
You can also use INPUT SELECTOR on
the receiver.
2
Press D.TUNING.
3
Press the numeric buttons to
enter the frequency.
Example 1: FM 102.50 MHz
Select 1 b 0 b 2 b 5 b 0
Example 2: AM 1,350 kHz
Select 1 b 3 b 5 b 0
4
Press ENTER.
You can also use MEMORY/ENTER on
the receiver.
Tip
If you have tuned in an AM station, adjust the
direction of the AM loop antenna for optimum
reception.
If you cannot tune in a station
Make sure you have entered the right
frequency. If not, repeat steps 2 to 4. If you
still cannot tune in a station, the frequency is
not used in your area.
SA-CD/CD TUNER
1
RECEIVER
MOVIE MUSIC
D.TUNING AUTO CAL
2
2 3
5 6
8 9
4
ENTER
MEMORY
67 US