5: Preparing The Receiver And The Remote - Sony STR-DG910 Operating Instructions Manual

5: Preparing the receiver
and the remote
Connecting the AC power cord
Connect the AC power cord to a wall outlet.
AC power cord
L L
R
R
FRONT A FRONT B
SPEAKERS
L L
R
R
SURROUND BACK SURROUND
EAKERS
Notes
• The AC OUTLET(s) on the rear of the receiver is a
switched outlet, which supplies power to the
connected component only while the receiver is
turned on.
• Make sure that the total power consumption of the
component(s) connected to the receiver's AC
OUTLET(s) does not exceed the wattage stated on
the rear panel. Do not connect high-wattage
electrical home appliances such as electric irons,
fans, or TVs to this outlet. This may cause a
malfunction.
32 US
AC OUTLET
AC OUTLET
To the wall outlet
Performing initial setup
operations
Before using the receiver for the first time,
initialize the receiver by performing the
following procedure. This procedure can also
be used to return settings you have made to
their factory defaults.
Be sure to use the buttons on the receiver for
this operation.
1,2
?/1
TONE MODE TUNING MODE
TONE TUNING
SPEAKERS
(OFF/A/B/A+B)
AUTO CAL MIC
MEMORY/ CATEGORY
ENTER MODE
VIDEO 3 IN/PORTABLE AV IN
PHONES
VIDEO L AUDIO R
3
1
Press ?/1 to turn off the
receiver.
2
Hold down ?/1 for 5 seconds.
"PUSH" and "ENTER" appears on the
display alternately.
3
Press MEMORY/ENTER.
After "CLEARING" appears on the
display for a while, "CLEARED"
appears.
The following items are reset to their
factory settings.
• All settings in the LEVEL, EQ, SUR,
TUNER, AUDIO, VIDEO, SYSTEM
and A. CAL menus.
• The sound field memorized for each
input and preset station.
• All sound field parameters.
• All preset stations.
• All index names for inputs and preset
stations.
• MASTER VOLUME is set to "VOL
MIN".
• Input is set to "DVD".
MASTER VOLUME
MULTI CHANNEL DECODING
DISPLAY INPUT MODE
INPUT SELECTOR
CATEGORY 2CH A.F.D. MOVIE MUSIC AUTO CAL DIRECT