No.
3
Manually slide cover open to left (return cover to Automatic operation
at end of quick start).
Add 5.0 gallons (model 810) of solvent to fill boil & immersion sumps
(model 101012 take 9.0 gallons).
Pour some fluid into condensate trough (as pointed with blue arrow on
picture above) to fill condensate/water separator reservoir.
Immersion sump overflows to fill boil sump.
Check sight tube on the lower left front of the system. Boil sump is full
when solvent is above the top of sight tube.
4
This (step 3) will allow Boil Sump Low Level alarm to be cleared.
Instruction
3-5