Levelling The Blades - Master MT Professional 50 Instructions For Use And Maintenance Manual

Replace the container back on top of the protection grid and fix it with the side retaining knobs (F).
9

Levelling the blades

Cutting effectiveness may be lost over time due to misalignment of the blades. Below, we describe how to solve this
problem, adjusting the distance between the blades and the grid to make them completely level. To carry out this
operation, the machine must be clean. You must also use protective gloves during the levelling process.
First, press the ON/OFF switch on the machine to switch it off.
1
Then disconnect it from the electricity supply by unplugging
it. IMPORTANT: The machine must be stopped and
disconnected before manipulating it.
Measure the distance between the two ends of the blades and the grid with a caliper or other measuring instrument, as shown in the
3
following images, to check that the blades are completely parallel to the grid of the machine.
If the distance is not the same at both ends, the blades must be levelled so they don´t affect the cutting process. Proceed as
described below.
Open the four latches on the grid and remove it to gain access to
4
the blades.
32
Loosen the two retaining knobs (F) that fix the container to the
2
body of the machine. Then, remove the container.
=
Loosen, without removing, the four nuts shown in the following
5
image using Allen key No. 3 (N) and a fixed wrench No. 10.
www.masterproducts.es
=