Checks To Carry Out Before Starting Work; Operating The Machine; Raw Material Conditions; Preparation Of The Raw Material - Master MT Professional 50 Instructions For Use And Maintenance Manual

Checks to carry out before starting work

Make sure the lid pull latches are
1
properly closed.

Operating the machine

Master Products distributes a cut-off mechanism that must not be altered by the consumer. If any task is carried out
on the machine, whether, for example, maintenance, regulation, adjustment, etc., it is essential to comply with the
safety regulations indicated in the Safety for the Operator section.

Raw material conditions

The MT Professional 50 and 75 machines were designed to work with all types of fresh flowers. Any materials not of
this nature must not be processed.

Preparation of the raw material

To be able to work with the MT Professional 50 and 75 machines, it is essential to separate the fresh flowers from
the branches beforehand. This process can be done manually, or accelerated with a high volume machines such as
the Master Bucker 200 or the Master Bucker 500.

How to use the machine

Once assembled and connected to the electricity supply, the machine is ready to be used.
IMPORTANT: The use of ear and eye protectors is recommended.
Switch on the machine by pressing the switch on the front of the
1
machine. This is used to activate/deactivate the blades of the body.
Check that the two lateral retaining
2
knobs (F) secure the container to the
machine body.
With the lower hatch of the dispenser (D) closed, open the upper
2
lid and fill it with freshly harvested and prepared flowers. Once full,
close the lid.
www.masterproducts.es
Close the covers and hatches of the machine.
3
27