Printer Cleaning - SATO PV3 User Manual

7. Printer Cleaning

If the interior of the printer is dusty, print quality can decline.
In such a case, follow the instructions below to clean the printer.
1) Open the paper cover and remove the paper, if present.
2) Clean the print head (A) using the cloth or cotton swab soaked in alcohol for medical.
Apply the cleaning pen
from the center to the edge of the print head (A) for cleaning.
3) Using the cloth or cotton swab soaked in alcohol for medical, remove the paper dust
from the black mark sensor (B).
(Sensor could be located in the middle or on left or on right)
4) Do not use the printer for 10 minutes after cleaning the print head (A) until the cleaning
agent of the cloth or cotton swab soaked in alcohol for medical has completely
evaporated and dried.
5) Insert the paper and close the paper cover.
Caution
Calle Llanos de Jerez 18 Nave 9 Coslada https://v10consumibles.com Tel: 910 269 309
Sensor (B)
• Make sure the printer power is turned off before cleaning.
• Wait for two to three minutes after power-off before print head cleaning
because it may be very hot.
• Do not to touch the heating region of the print head with your hand
while cleaning it.
• The print head may be damaged by static electricity.
• Avoid scratching the print head.
V10 CONSUMIBLES S.L.
Print head (A)