Pentair FRESHPOINT EASY FLOW Replacement Instructions

FRESHPOINT EASY FLOW
FRESHPOINT® EASY FLOW UNDER COUNTER
WATER FILTRATION SYSTEM
FILTER REPLACEMENT INSTRUCTIONS
1.
Shut off the cold water to your faucet by turning
cold-water valve, under the sink, clockwise.
2.
Turn on cold water faucet to release pressure
and to drain water from hose.
3.
Press and hold Filter Release Button while holding firmly
on the base. Pull up on the exhausted filter to remove.
4.
Insert the new filter into base of the FreshPoint
Easy Flow Water Filtration System. An audible
click ensures proper sealing of the filter.
5.
Open water shutoff valve by turning counter-clockwise.
6.
Allow water to flow with faucet open completely
for fifteen (15) minutes to flush the filter.
NOTE: A drinking water filter may contain carbon fines
(very fine black particles). If carbon fines appear in
the water, continue flushing until none are present.
NOTE: Initially, filtered water may appear cloudy.
If cloudiness in glass of water rises to the top, the cause
is likely due to air in the water. The air (and cloudiness)
will disappear within a few weeks after installation.
7.
Press and hold small Filter Life Indicator Button for five
(5) seconds. A blue light on the Filter Life Indicator will
flash four (4) times to confirm timer has started.
13845 Bishops Dr. | Suite 200 | Brookfield, WI 53005 | United States
P: 262.238.4400 | Customer Service: 800.279.9404 | tech-support@pentair.com | pentair.com
All indicated Pentair trademarks and logos are property of Pentair. Third party registered and unregistered trademarks and logos are the property of their respective owners.
© 2020 Pentair. All rights reserved.
4007514 Rev A NV20
2
1
4
7
3
6
5